7 simple ways to adjust your bike riding position

Tweaking your cockpit helps create comfort in addition to making it possible for you to better create the power to have the best control and performance. Here are 7 simple ways to adjust your bike riding and make your trip more enjoyable. Let’s refer to offline!

1.Hand and stem selection

We can always hit wider handlebars with anything over 750mm with short stems below 70mm because they have better control.

7 ways to adjust your riding position -1
Uses a short stem and wide handlebars for easy control

If you are buying a handlebar make sure it’s at least 750mm wide as you can always cut it down if it’s too wide. Look for a car with a 7-9 degree backsweep for a comfortable wrist rest.

2.Stock plate and bar pitch

Try lowering it down with a gasket or two so it can be close to the top tube if you feel like you can’t load your car front enough.

If you are on a steep road and want a little more safety, raise it. You can create more space for yourself by quickly rolling the bars forward for a higher and further user interface.

7 ways to adjust your riding position -2
Don’t tilt your brake lever too far – you will put too much tension on your wrists
7 ways to adjust your riding position -3
Check if your back finger has been placed in the lever position

3. Position the brake lever

Modern disc brakes should be strong enough to be able to brake with one finger and should be in that position. With the blade close enough to stretch the other two to three thumbs tighten on the bars.

Move your brake lever inward to the point where your index finger can make the most of the mechanical lever system near the top where the lever is.

Additionally, the blade tilts toward the windows for about three to five hours (seen from the drive side) to get a right angle too low to grab the brake as well as reduce stability from the wrist area. If this feels too high, remember that the levers will likely tilt forward as you cycle downhill.

4.Clean your cables

Keep the cable as far away from the frame as possible; otherwise ensure it can be properly shielded from wear at the point in contact with the frame.

7 ways to adjust your riding position -4
Re-read the brake cable neatly

Try using small plastic objects to keep the cables tidy together and when replacing cables can ensure they are not of the right size too long.

5. Reposition the brake lever

The brake lever should be set to the standard riding position. Depending on the brand, this could be either side brake. Use the loosen wrench to allow the brake lever assembly to be moved to a position that is suitable for the width you feel most comfortable with.

6.Make good grip with both

One of the most technically important things is that they give you complete control to understand your touch points so that you can steer the direction so you won’t feel the feelings. too vague.

Choose sizes that allow your hand to be easily placed around it as well as your fingers just touching the palm of your hand.

Silicone handles can provide more comfort on plastic handles. With a bulky outside buckle necklace can also completely exert pressure on the palms of the extensions.

7 wider bar than ‘fake’

You can also cheat a little here to have more efficient bars, as long as you push your lock pin to about 5mm on top of the bar with support about 2x5mm = 1cm you will see the results. the most surprising and reliable for its steering wheel.

Above are extremely helpful shares about how to customize the right way to have the most comfortable trip!

>> Maybe you are interested: Guide for adjusting your bike rider’s height


Source content: 7 simple ways to adjust your bike riding position

>> Bike How

Click Here to Leave a Comment Below 0 comments