Instructions for replacing bicycle brake cables

Instructions for replacing bicycle brake cables -1

In the process of using the bicycle, there will be some cases for the brake as the brake cable gets dry, hard and prevents them from working effectively. At this time, it is necessary to carry out a maintenance check and replace the bicycle brake cable immediately to ensure the safety and the best performance for your bike. In the article below, we will guide you through the job Replace the bike brake cable the simplest and most detailed offline!

1. Check the brake cable

Check the brake cable to see if the brake cable is frayed or hard. When either of these signs is detected, your brake cable has been damaged from the inside or from external impacts. Any friction against the cable will cause your brakes to function improperly. Please proceed to check the damage of the outer shell, any bends in the wire. You should replace both the cable and the cover if they are damaged.

Instructions for replacing bicycle brake cables -1
Check the bike brake cable
Instructions for replacing bicycle brake cables -2
Check the brake cable cover

Getting the correct cables, it is important that you make sure that you have the correct replacement cable that matches your vehicle’s cable. Do a check on the top of the cable and see if it matches the cables you are preparing to replace. Different types of brakes for straight and rest control bars.

Instructions for replacing bicycle brake cables -3
Locate to loosen the brake cable

Remove the cable ties, locate the cable clamp and use the hexagon to be able to open. Don’t let the rubber slips off the cables as you’ll definitely need to put them back on.

Instructions for replacing bicycle brake cables -4
Turn the cable knob on the steering wheel

Remove the regulator by looking for the regulator right next to the brake lever on the control bar, which is a small knob that can be completely rotated using your fingers.

>> See more: How to adjust the bicycle brake

Instructions for replacing bicycle brake cables-5
Open the brake lever to remove the cable

Squeeze the brake lever at the control hand to open the brake lever controller, remove the cable gently, the cable end is hooked to an opening at the main brake lever so just pull gently to remove it.

Instructions for replacing bicycle brake cables -6
Insert the new brake cable into the cable cover

If the outer cable cover is old, it should be replaced but keep the correct length compared to the old cable. Replace the inner cable to ensure the same length as the old cable. Use the dedicated cable cutter to cut the cable with the sweetest cuts. Slide the new cable into the hole of the cable cover and check the suitability of these 2 components.

Instructions for replacing bicycle brake cables -7
Insert the new end of the brake cable into the lever

Use the end of the cable to gently push into the brake lever position in the regulator slot. On the other end the through cables are pushed into the inner sheath, sliding the rubber pad in order to prevent dirt from entering the cable. Slide the cable into the clip position and use the hexagon to lock it temporarily. Reconnect the brake by pulling it over and cutting it into the hole. Make sure the metal pieces are correctly seated.

Instructions for replacing bicycle brake cables -8
Tighten the rear cable adjuster

Hold the back cable firmly, loosen the hexagon lock and pull the cable then perform cable tightening then perform the lever tightening several times to be able to pull the new cable, perform tension adjustment when necessary, needs . Check that the cable sheath is now in the correct position of the regulator. Pulling the brake repeatedly this ensures every part can be combined smoothly. If the brake feels loose, tighten it.

Instructions for replacing bicycle brake cables -8
The last step is to cut off excess brake cables

After all is done, it’s time for us to start cutting off the excess brake cables. Leave about 3 inches (7.6cm) of the cable clamped from the brake clamp. Squeeze it in place with pliers or with the end of the cut cable.

Above are the basic instructions for you to replace one sports bike brake easily . If you are a beginner then you should definitely check out those playing sports bike Have experience to learn more about this repair operation.

According to Kiwi How


Source content: Instructions for replacing bicycle brake cables

>> Bike How

Rate this post

Be the first to comment

Leave a Reply

Your email address will not be published.


*