Instructions on how to maintain a sports bicycle brake

Bicycle brake This part is easy to wear out quickly and often have minor troubles due to heavy contact, dust. So for the brake to work well and smooth, need to pay attention to hygiene and maintenance? In the article below, we will share more useful information to help you perform good maintenance on your own.

There are two types of brakes in the current vehicle: the braces and disc brakes, in the disc brakes, the mechanical disc brake and the oil disc brake are divided (oil brake is expensive and works well, is quieter than the mechanical brake). Here we will go into the maintenance of each specific brake!

1. Maintenance of the bicycle rim brake

-2 the pads are too far from the cheeks, squeezing the brakes with strong force, the brake doesn’t eat as before

Due to the direct friction of the gasket with the rim, it is worn out over time

+ Due to too much dirt, mud and trash, and brake rim and tire

Regularly carry out checking the thickness of sports bike brake every 4-6 months of use or before and after trips. The thickness of the brakes depends on a lot of factors, possibly due to the time used, the amount of force applied, and the ability to travel often.

Absolutely do not let the brake pads become too worn, leading to a situation where the brake iron holder is in direct contact with the rim of the rim, causing damage such as rim curvature, scratching the rim, even causing the rim to shock and break.

Proceed to clean sport bicycle on a regular basis to remove mud, dirt and litter from the brake and rim, cleaning the brake pads.

2. Disc brake maintenance

2.1 Mechanical disc brake

When riding if there are abnormal signs, the brake usually makes a creaking noise, or lightening

There are many reasons the bicycle brake is ringing This could be due to:

+ Brakes are in contact with the brake pads due to deflection

+ Pads are worn, cheeks close to the disc

+ Mud, soil and garbage are stuck a lot and cause the brake to be stuck

At this point you should calm down and check the brakes again. Observe bicycle brake if the brake pads are not being fed to the rim, it may be due to a long period of use that the brake position may be deviated completely to the side. If it is deflected, it is possible to use tools to can re-align the screws and align the position evenly with the rim.

Check the brake pad, if it is no longer thick due to excessive wear, replace the brake pad by gently unscrewing the screw behind the brake pad to let the rubber gaskets come out of the snap. Iron . Immediately use a new rubber gasket for the replacement.

– In many cases, if the brake part gets too much mud, you should remove the brake and perform cleaning from the brake components. It is advised to limit direct discharge to the brake pads because they are susceptible to damage or rust.

2.2 Oil brake

Feeling unstable braking force causes abnormal braking

– It may be due to the amount of oil in the brake being dropped

For those who have no experience of oiling, you should not manually remove the brake to pump oil, but bring it to the bicycle repair shop so that the experienced technicians to repair the brake fluid pump are more technical and accurate. .

One thing to note for both the mechanical disc brake and the oil disc brake is that when you do not handle the motor disc, you must use a soft cloth to clean the lining because the skin on your hands is often oily, this oil often sticks to the disc. It may affect the brake performance.

Absolutely not apply grease to the brake to avoid hissing or maintenance because the principle of brake operation is based on friction, if the friction decreases, the braking ability will also decrease. Causes undue disadvantages in the braking process.

If your brakes are in a state of too hissing, creaking continuously, do not think that grease will be the answer. If you use the brace brake, chances are it could come from the brake pads that were not carefully laid out or even mostly worn. If you keep using the disc brake a lot when it whistles for no reason at all. However, almost every time the brake starts to sound is when the brake pads are dirty. Cleaning or replacing the brake pads is essential to bring peace to the pedestrian.

With the above sharing, hopefully you can handle these signs well on your own without being embarrassed. If you do not have mechanical knowledge about brake maintenance you can refer to more information Sports bicycle maintenance consulting from experienced people for better maintenance.